DS-400

The Spears Dri-Splice Seal designed into each wire hole enables you to stock one connector for all applications. The Dri-Splice Seal features an interference webbing which expands to accommodate #18, #14, #12, or #10 gauge wire sizes. In the event only two holes are used, the Dri-Splice Seal prevents sealant from leaking out through the third hole.

• All the features of the DS-100, plus the added benefit of being
  pre-filled with Dielectric Silicone Sealant
• Reduced inventory requirements
• Insures proper amount and type of Sealant every time
• Eliminates costly waste and clean-up
• Makes installations quick, clean and efficient
• For use in electrical systems with 30v or less

DS-400 Dri-Splice Wire Connector Installation Information

1. Insert wires through holes in base of body.
2. Twist stripped wires together and apply crimp sleeve with an indent type crimping tool. Trim excess bare wire.
3. DS-100 ONLY — Fill Plug to brim with DS-300 sealant.
4. Invert body and insert plug into body until it snaps tight.
5. Push wires all the way into the plug to completely seal the crimp sleeve.
6. DS-100 ONLY — Be certain sealant has formed into all holes in body.